Home Products GNSS Antenna EV226 GNSS Antenna
EV226
Description
The E V 2 2 6 antenna is a high-precision device that is capable of supporting GPS, BDS, GLONASS, and full-band systems. It is designed to meet the precise positioning requirements of vehicles.
Technical Features
1. The passive antenna exhibits high gain, a wide beam width, and a low elevation angle, resulting in optimal signal reception. It is capable of receiving networking B3 frequency points, thereby enhancing the stability of the system in environments with significant satellite signal interference.
3. The device is of a small size, lightweight, and boasts a reliable structure and protection level of up to IP67, thereby markedly enhancing the overall reliability of the UAV/vehicle. This includes waterproofing, impact resistance, and other features.
4. The device exhibits robust anti-interference capabilities, with high antenna out-of-band suppression, enabling effective avoidance of base station and other signal interference caused by system instability.
Application
• Unmanned delivery vehicle
• Self-driving truck
• Self-drive bus
• Self-driving cab
• Unmanned & unpiloted
Technical parameters |
|
Passive antenna characteristics |
|
Frequency Range
|
BDS: B1I/B2I/B2A
|
|
GPS:L1/L2/L5
|
|
GLONASS: G1/G2
|
|
GALILEO: E1/E6/E5b
|
|
L-Band
|
Antenna Impedance
|
50Ω
|
Polarization |
RHCP |
Antenna axis ratio |
≤3dB |
Azimuth coverage |
0°~360° |
VSWR |
≤1.5 |
Maximum gain |
4dBi |
Phase center error |
±3mm |
Low Noise Amplifier Characteristics |
|
LNA Gain
|
33±2dB |
Noise figure |
≤2dB |
VSWR
|
≤2.0 |
Passband ripple |
±2dB |
Operating voltage |
DC3.3~12V |
Operating current |
≤50mA |
Structural and environmental adaptability |
|
Antenna size
|
L75*W75*H30mm
|
Weight
|
≤70g(weight without cable)
|
Connector
|
SMA male
|
Installation
|
Magnetic suction
|
Waterproof rating
|
IP67
|
Impact
|
Meet GB/T 2423.5(Note 1) |
Waterproof rating |
IP67 |
Operating TEMP |
-40℃~+95℃ |
Storage TEMP |
-55℃~+95℃ |
Storage humidity |
95% non-condensing |
Structural drawing (dimensional tolerances ± 0.3 mm not noted)
|
|
|
|
|
|
Documentation
Serial No.
|
Contents
|
Version
|
Date
|
|
All chapters
|
V1.0
|
2023-2-26
|
2 |
|
|
|
3 |
|
|
|
4 |
|
|
|
Prepared by:
|
Checked by:
|
Approved by: |